The employer must ensure the value of the safety coefficient of a chain used for slinging of cargo lifting appliance to be a value equivalent to or more than the value listed in the following items in accordance with the category of the chains listed in each item:
事業者は、揚貨装置の玉掛けに用いる鎖の安全係数については、次の各号に掲げる鎖の区分に応じ、当該各号に掲げる値以上としなければならない。
chains falling under all of the following requirements:4
次のいずれにも該当する鎖 四
those with an elongation not more than 0.5 % when loaded with one half of the breaking load;
切断荷重の二分の一の荷重で引つ張つた場合において、その伸びが〇・五パーセント以下のものであること。
those with a tensile strength of 400 N/mm2 or more and with elongation that is equal to or more than the value listed in the right column of the following table in accordance with the tensile strength value listed in the left column of the same table;
| Tensile Strength (Unit: N/mm2) | Elongation (Unit: Percent) |
| 400 or more and less than 630 | 20 |
| 630 or more and less than 1,000 | 17 |
| 1,000 or more | 15 |
その引張強さの値が四百ニュートン毎平方ミリメートル以上であり、かつ、その伸びが、次の表の上欄に掲げる引張強さの値に応じ、それぞれ同表の下欄に掲げる値以上となるものであること。
| 引張強さ(単位 ニュートン毎平方ミリメートル) | 伸び(単位 パーセント) |
| 四百以上六百三十未満 | 二十 |
| 六百三十以上千未満 | 十七 |
| 千以上 | 十五 |
chains other than those falling under the preceding item:5
前号に該当しない鎖 五
The safety coefficient prescribed in the preceding paragraph is to be the value obtained by dividing the value of the breaking load of the chain by the value of the maximum load applied to the chain.
前項の安全係数は、鎖の切断荷重の値を、当該鎖にかかる荷重の最大の値で除した値とする。