Search

Search provisions, jump to a law or an article

1 article

Article 572Steel Pipe Scaffoldings Using Members, etc. Other Than Those Listed in Appended Table 8, items (i) through (iii) of the Order

第五百七十二条(令別表第八第一号から第三号までに掲げる部材以外の部材等を用いる鋼管足場)

As regards steel pipe scaffoldings composed of members other than those listed in Appended Table 8, items (i) through (iii) of the Order or steel pipes other than those conforming to the standard for steel pipes for single-pipe scaffolding, the employer must not use them unless the value of the maximum bending moment calculated with each fulcrum interval regarded as a simple beam is equal to or less than the value obtained by multiplying the section modulus of the steel pipe by 1/1.5 of the yield point value of the material of the steel pipe (for those whose yield point value is unknown, 1/2 of the tensile strength value) and by the coefficient listed in the right column of the following table in accordance with the ratio of thickness to outer diameter of steel pipe listed in the left column of the same table (when joints exist, 3/4 of this value), in addition to conforming to the requirements set forth in Article 570, paragraph (1).

Ratio of Thickness to Outer Diameter of Steel PipeCoefficient
Thickness of 1/14 or more of outer diameter1
Thickness of 1/20 or more and less than 1/14 of outer diameter0.9
Thickness of 1/31 or more and less than 1/20 of outer diameter0.8

事業者は、令別表第八第一号から第三号までに掲げる部材以外の部材又は単管足場用鋼管規格に適合する鋼管以外の鋼管を用いて構成される鋼管足場については、第五百七十条第一項に定めるところによるほか、各支点間を単純ばりとして計算した最大曲げモーメントの値が、鋼管の断面係数に、鋼管の材料の降伏強さの値(降伏強さの値が明らかでないものについては、引張強さの値の二分の一の値)の一・五分の一及び次の表の上欄に掲げる鋼管の肉厚と外径との比に応じ、それぞれ同表の下欄に掲げる係数を乗じて得た値(継手のある場合には、この値の四分の三)以下のものでなければ使用してはならない。

鋼管の肉厚と外径との比係数
肉厚が外径の十四分の一以上一
肉厚が外径の二十分の一以上十四分の一未満〇・九
肉厚が外径の三十一分の一以上二十分の一未満〇・八

Read this with the articles around it

© 2026 japanlaw.orgA copy for reading and reference — not an official source, and not legal advice. Only the Japanese text published by the government has legal effect.Run by Genjido LLC (源氏道合同会社) · contact@genjido.comContactSourcesTermsPrivacy