Search

Search provisions, jump to a law or an article

1 article

Article 563Work Floor

第五百六十三条(作業床)

The employer must provide a workplace on scaffolding (excluding single-row scaffolding; the same applies in item (iii)) having a height of 2 m or more with a work floor that conforms to the following requirements:

事業者は、足場(一側足場を除く。第三号において同じ。)における高さ二メートル以上の作業場所には、次に定めるところにより、作業床を設けなければならない。

the bending stress value of floor materials calculated in accordance with the distance between fulcrums and the load during work is not to exceed the allowable bending stress value listed in the right column of the following table in accordance with the type of wood listed in the left column of the same table.

Type of WoodAllowable Bending Stress (Unit: N/cm2)
Japanese red pine, Japanese black pine, Japanese larch, hiba, hinoki, Japanese hemlock, Douglas fir or Port Orford cedar1,320
Japanese cedar, fir, Ezo spruce, Sakhalin fir, western red cedar or western hemlock1,030
Oak1,910
Japanese chestnut, Japanese oak, Japanese beech or keyaki1,470
Plywood made of apitong or kapur bonded with phenol resin1,620

床材は、支点間隔及び作業時の荷重に応じて計算した曲げ応力の値が、次の表の上欄に掲げる木材の種類に応じ、それぞれ同表の下欄に掲げる許容曲げ応力の値を超えないこと。

木材の種類許容曲げ応力(単位 ニュートン毎平方センチメートル)
あかまつ、くろまつ、からまつ、ひば、ひのき、つが、べいまつ又はべいひ一、三二〇
すぎ、もみ、えぞまつ、とどまつ、べいすぎ又はべいつが一、〇三〇
かし一、九一〇
くり、なら、ぶな又はけやき一、四七〇
アピトン又はカポールをフエノール樹脂により接着した合板一、六二〇

except in the case of hanging scaffolding, the width, the gap between floor materials and the gap between floor materials and the standards are to be as provided below:

つり足場の場合を除き、幅、床材間の隙間及び床材と建地との隙間は、次に定めるところによること。

to make the width 40 cm or more;

幅は、四十センチメートル以上とすること。

to make the gap between floor materials 3 cm or less; and

床材間の隙間は、三センチメートル以下とすること。

to make the gap between floor materials and the standards less than 12 cm;

床材と建地との隙間は、十二センチメートル未満とすること。

at places where there is a risk of danger to workers due to falling, to provide, in accordance with the type of scaffolding listed below, the following equipment (limited to equipment that has a sturdy structure, is not likely to bend, and has no significant damage, deformation or corrosion; hereinafter referred to as "scaffold fall prevention equipment"):

墜落により労働者に危険を及ぼすおそれのある箇所には、次に掲げる足場の種類に応じて、それぞれ次に掲げる設備(丈夫な構造の設備であつて、たわみが生ずるおそれがなく、かつ、著しい損傷、変形又は腐食がないものに限る。以下「足場用墜落防止設備」という。)を設けること。

for frame scaffolding (excluding the portion pertaining to the end face; the same applies in (b)), either of the following equipment:

わく組足場(妻面に係る部分を除く。ロにおいて同じ。) 次のいずれかの設備

cross bracing and either a crosspiece with a height of 15 cm or more and 40 cm or less or a toe board with a height of 15 cm or more, or equipment having functions equal or superior to these; or

交さ筋かい及び高さ十五センチメートル以上四十センチメートル以下の桟若しくは高さ十五センチメートル以上の幅木又はこれらと同等以上の機能を有する設備

a handrail frame;

手すりわく

for scaffolding other than frame scaffolding, handrails, etc. and mid-rails, etc.;

わく組足場以外の足場 手すり等及び中桟等

to use brackets, ledgers, girders, trestle or other supporting materials for the work floor having a strength sufficient to bear the load applied; and

腕木、布、はり、脚立その他作業床の支持物は、これにかかる荷重によつて破壊するおそれのないものを使用すること。

to fix the floor boards to two supports or more to prevent displacement or coming off, excluding hanging scaffoldings.

つり足場の場合を除き、床材は、転位し、又は脱落しないように二以上の支持物に取り付けること。

when there is a risk of endangering workers due to objects falling in the course of work, to provide toe boards, mesh sheets or protective nets with a height of 10 cm or more, or equipment having functions equal or superior to these (hereinafter referred to as "toe board, etc."); provided, however, that this does not apply where a prohibited entry area has been established in the case where the equipment provided pursuant to the provisions of item (iii) has functions equal or superior to toe boards, etc., or in the case where it is considerably difficult to provide toe boards, etc. due to the nature of the work or where toe boards, etc. are temporarily removed due to necessity for work.

作業のため物体が落下することにより、労働者に危険を及ぼすおそれのあるときは、高さ十センチメートル以上の幅木、メッシュシート若しくは防網又はこれらと同等以上の機能を有する設備(以下「幅木等」という。)を設けること。ただし、第三号の規定に基づき設けた設備が幅木等と同等以上の機能を有する場合又は作業の性質上幅木等を設けることが著しく困難な場合若しくは作業の必要上臨時に幅木等を取り外す場合において、立入区域を設定したときは、この限りでない。

The provisions of item (ii), (c) of the preceding paragraph do not apply where, in a case falling under any of the following items, measures such as setting a protective net to prevent danger to workers due to falling have been taken at a place where the gap between floor materials and the standards is 12 cm or more.

前項第二号ハの規定は、次の各号のいずれかに該当する場合であつて、床材と建地との隙間が十二センチメートル以上の箇所に防網を張る等墜落による労働者の危険を防止するための措置を講じたときは、適用しない。

where the sum of the gaps between the standards and both ends of the floor materials in the direction of the beam is less than 24 cm; or

はり間方向における建地と床材の両端との隙間の和が二十四センチメートル未満の場合

where it is difficult, due to the nature of the work, to make the sum of the gaps between the standards and both ends of the floor materials in the direction of the beam less than 24 cm.

はり間方向における建地と床材の両端との隙間の和を二十四センチメートル未満とすることが作業の性質上困難な場合

The provisions of paragraph (1), item (iii) do not apply where it is considerably difficult to provide scaffold fall prevention equipment due to the nature of the work or where scaffold fall prevention equipment is temporarily removed due to necessity for work, and the following measures are taken:

第一項第三号の規定は、作業の性質上足場用墜落防止設備を設けることが著しく困難な場合又は作業の必要上臨時に足場用墜落防止設備を取り外す場合において、次の措置を講じたときは、適用しない。

to provide equipment, etc., for safely attaching fall arrest equipment with the required performance, and take measures to have workers use fall arrest equipment with the required performance, or measures having effects equal or superior to those measures; and

要求性能墜落制止用器具を安全に取り付けるための設備等を設け、かつ、労働者に要求性能墜落制止用器具を使用させる措置又はこれと同等以上の効果を有する措置を講ずること。

to prohibit persons other than persons engaged in work concerned with the place where the measures set forth in the preceding item are taken from entering that place, by displaying at a readily visible place that such entry is prohibited or by other methods.

前号の措置を講ずる箇所に関係する作業従事者以外の者が立ち入ることについて、禁止する旨を見やすい箇所に表示することその他の方法により禁止すること。

The provisions of paragraph (1), item (v) do not apply when the case falls under any of the following items:

第一項第五号の規定は、次の各号のいずれかに該当するときは、適用しない。

when boards having a width of 20 cm or more, a thickness of 3.5 cm or more and a length of 3.6 m or more are used for the floor materials and are to be moved in accordance with the work, and when the following measures are taken:

幅が二十センチメートル以上、厚さが三・五センチメートル以上、長さが三・六メートル以上の板を床材として用い、これを作業に応じて移動させる場合で、次の措置を講ずるとき。

to lay scaffolding boards across three or more supports;

足場板は、三以上の支持物に掛け渡すこと。

the length of projection of scaffolding boards from the fulcrums is 10 cm or longer, and is one-eighteenth or less of the length of the scaffolding boards, excluding the cases where there is no risk of workers putting their foot on the projections;

足場板の支点からの突出部の長さは、十センチメートル以上とし、かつ、労働者が当該突出部に足を掛けるおそれのない場合を除き、足場板の長さの十八分の一以下とすること。

when scaffolding boards are to be piled in the longitudinal direction, they are to be piled on their fulcrum, and the length of the piled part is to be 20 cm or more; and

足場板を長手方向に重ねるときは、支点の上で重ね、その重ねた部分の長さは、二十センチメートル以上とすること。

when boards having a width of 30 cm or more, a thickness of 6 cm or more and a length of 4 m or more are used, and the measures provided in (b) and (c) of the preceding item are taken.

幅が三十センチメートル以上、厚さが六センチメートル以上、長さが四メートル以上の板を床材として用い、かつ、前号ロ及びハに定める措置を講ずるとき。

When the employer has temporarily removed scaffold fall prevention equipment due to necessity for work pursuant to the provisions of paragraph (3), the employer must restore that equipment to its original condition immediately after the necessity has ceased.

事業者は、第三項の規定により作業の必要上臨時に足場用墜落防止設備を取り外したときは、その必要がなくなつた後、直ちに当該設備を原状に復さなければならない。

In the case referred to in paragraph (3), a worker who has been ordered to use fall arrest equipment with the required performance must use it.

労働者は、第三項の場合において、要求性能墜落制止用器具の使用を命じられたときは、これを使用しなければならない。

Read this with the articles around it

© 2026 japanlaw.orgA copy for reading and reference — not an official source, and not legal advice. Only the Japanese text published by the government has legal effect.Run by Genjido LLC (源氏道合同会社) · contact@genjido.comContactSourcesTermsPrivacy