As regards the work set forth in Article 6, item (vii) of the Order, the employer must appoint an operations supervisor of press machines from the persons who have completed the skill training course for operations supervisor of press machines.
第百三十四条
(プレス機械作業主任者の職務)Duties of the Operations Supervisor of Press Machines
第一項
事業者は、プレス機械作業主任者に、次の事項を行なわせなければならない。
The employer must have the operations supervisor of press machines carry out the following matters:
一
プレス機械及びその安全装置を点検すること。
to inspect the press machine and its safety device;
二
プレス機械及びその安全装置に異常を認めたときは、直ちに必要な措置をとること。
to immediately take necessary measures when having found any abnormality in the press machine and its safety device;
三
プレス機械及びその安全装置に切替えキースイツチを設けたときは、当該キーを保管すること。
To store the key when having equipped a press machine or its safety device with a changeover key switch; and
四
金型の取付け、取りはずし及び調整の作業を直接指揮すること。
to directly supervise the work of fitting, removing and adjusting a die.
第百三十四条の二
(切替えキースイツチのキーの保管等)Storing the Key of a Changeover Key Switch
When work other than those set forth in Article 6, item (vii) of the Order among work using a power press are carried out, and a changeover key switch for the power press and its safety device have been provided, the employer must designate a person who stores the key switch, and have the person store the key.
As regards a power press, the employer must carry out self-inspections for the following matters periodically once every period not exceeding a year; provided, however, that this does not apply to the non-use period of a power press which is not used for a period exceeding one year:
一
クランクシヤフト、フライホイールその他動力伝達装置の異常の有無
abnormalities in crankshafts, flywheels and other power transmission devices;
二
クラツチ、ブレーキその他制御系統の異常の有無
abnormalities in a clutch, a brake and other controlling systems;
三
一行程一停止機構、急停止機構及び非常停止装置の異常の有無
abnormalities in an anti-repeat device, a quick-stop device or an emergency stop device;
四
スライド、コネクチングロツドその他スライド関係の異常の有無
abnormalities in a slide, a connecting rod or other slide-related parts;
五
電磁弁、圧力調整弁その他空圧系統の異常の有無
abnormalities in a magnet valve, a pressure control valve or other air pressure systems;
六
電磁弁、油圧ポンプその他油圧系統の異常の有無
abnormalities in a magnet valve, a hydraulic pump or other hydraulic systems;
七
リミツトスイツチ、リレーその他電気系統の異常の有無
abnormalities in a limit switch, a relay or other electrical systems;
八
ダイクツシヨン及びその附属機器の異常の有無
abnormalities in a die cushion and its accessories; and
九
スライドによる危険を防止するための機構の異常の有無
abnormalities in the mechanism for preventing dangers due to a slide.
As regards the power press set forth in the proviso of the preceding paragraph, the employer must carry out self-inspection for the matters listed in each item of the same paragraph before resuming the operation.
As regards a power-driven shearing machine, the employer must carry out self-inspections for the following matters periodically once every period not exceeding a year; provided, however, that this does not apply to the non-use period of a power-driven shearing machine which is not used for a period exceeding one year:
一
クラツチ及びブレーキの異常の有無
abnormalities in a clutch and a brake;
二
スライド機構の異常の有無
abnormalities in a sliding mechanism;
三
一行程一停止機構、急停止機構及び非常停止装置の異常の有無
abnormalities in an anti-repeat device, a quick-stop device, and an emergency stop device;
四
電磁弁、減圧弁及び圧力計の異常の有無
abnormalities in a magnet valve, a pressure-reducing valve and a pressure gauge; and
As regards the shearing machine set forth in the proviso of the preceding paragraph, the employer must carry out self-inspection for the matters listed in each item of the same paragraph before resuming the operation.
第百三十五条の二
(定期自主検査の記録)Record of Periodical Self-inspections
第一項
事業者は、前二条の自主検査を行つたときは、次の事項を記録し、これを三年間保存しなければならない。
When having carried out the self-inspections set forth in the preceding two Articles, the employer must record the following matters and preserve the records for three years:
一
検査年月日
the date of the inspection;
二
検査方法
the method of the inspection;
三
検査箇所
the parts of a machine inspected;
四
検査の結果
the results of the inspection;
五
検査を実施した者の氏名
the name of the person who has carried out the inspection; and
六
検査の結果に基づいて補修等の措置を講じたときは、その内容
when measures such as repairs have been taken based on the result of the inspection, the details of the repairs.
The self-inspection prescribed by the Order of the Ministry of Health, Labour and Welfare set forth in Article 45, paragraph (2) of the Act pertaining to a power press (hereinafter referred to as the "specified inspection") is to be the self-inspection prescribed in Article 134-3.
A person who has the qualifications prescribed by the Order of the Ministry of Health, Labour and Welfare set forth in Article 45, paragraph (2) of the Act pertaining to a power press is to be a person who falls under any of the following items:
一
次のいずれかに該当する者で、厚生労働大臣が定める研修を修了したもの
a person who falls under any of the following sub-items and has completed the training course specified by the Minister of Health, Labour and Welfare:
a person who has majored in and graduated from an engineering course of a university or a technical college under the School Education Act (including a person who has been conferred a bachelor's degree by the National Institution for Academic Degrees and Quality Enhancement of Higher Education (limited to one who majored in such a course), a person found to have equivalent or greater scholastic ability, and a person who majored in such a course and completed the first-stage course of a professional university; the same applies in Article 151-24, paragraph (2), item (i), (a)), and has experience of having been engaged in the work of inspection or maintenance of a power press for two years or longer, or design or manufacture of a power press for five years or longer;
a person who has majored in and graduated from an engineering course of a senior high school or a secondary education school under the School Education Act and has experience of having been engaged in the work of inspection or maintenance of a power press for four years or longer, or design or manufacture of a power press for seven years or longer;
a person who has experience of having been engaged in the work of inspection or maintenance of a power press for seven years or longer, or design or manufacture of a power press for 10 years or longer; or
a person who has completed the skill training course for operations supervisor of press machine listed in the Appended Table 18, item (2) of the Act and who has experience of having been engaged in the work using a power press for 10 years or longer; or
二
その他厚生労働大臣が定める者
other persons specified by the Minister of Health, Labour and Welfare.
As regards the application of the provisions of the preceding Article when having a registered inspection agency set forth in Article 45, paragraph (2) of the Act (hereinafter referred to as the "registered inspection agency") conduct the specified inspection pertaining to a power press, the term "the name of the person who has carried out the inspection" in item (v) of the same Article is deemed to be replaced with "the name of the registered inspection agency."
When having carried out the specified inspection pertaining to a power press, the employer must affix an inspection sticker stating the month and year when the specified inspection was carried out at a readily visible part of the power press.
When having found any abnormality in carrying out the self-inspection set forth in Article 134-3 or Article 135, or the inspection set forth in the preceding Article, the employer must make repairs or take other necessary measures.
第五節 遠心機械
第百三十八条
(ふたの取付け)Fitting of a Lid
第一項
事業者は、遠心機械には、ふたを設けなければならない。
The employer must provide a lid on a centrifugal machine.
第百三十九条
(内容物を取り出す場合の運転停止)Suspension of Operation in Taking Out the Contents
When taking out the contents of a centrifugal machine (excluding the centrifugal machine constructed so that the content is automatically taken out), the employer must suspend the operation of the centrifugal machine.
第百四十条
(最高使用回転数をこえる使用の禁止)Prohibition of Use at Speeds Exceeding Maximum Allowable Rotation
第一項
事業者は、遠心機械については、その最高使用回転数をこえて使用してはならない。
As regards a centrifugal machine, the employer must not use the centrifugal machine at a speed exceeding its maximum allowable rotating speed.
As regards a power-driven centrifugal machine, the employer must carry out self-inspections for the following matters periodically once every period not exceeding a year; provided, however, that this does not apply to the non-use period of a centrifugal machine which is not used for a period exceeding one year:
一
回転体の異常の有無
abnormalities in rotor;
二
主軸の軸受部の異常の有無
abnormalities in bearing parts of the main shafts;
三
ブレーキの異常の有無
abnormalities in brake;
四
外わくの異常の有無
abnormalities in the outer frame; and
五
前各号に掲げる部分のボルトのゆるみの有無
the slackness of a bolt used in the parts listed in each preceding item.
As regards the centrifugal machine set forth in the proviso of the preceding paragraph, the employer must carry out self-inspection for the matters listed in each item of the same paragraph before resuming the use.
第三項
事業者は、前二項の自主検査を行つたときは、次の事項を記録し、これを三年間保存しなければならない。
When having carried out the self-inspections set forth in the preceding two paragraphs, the employer must record the following matters and preserve the record for three years:
一
検査年月日
the date of the inspection;
二
検査方法
the method of the inspection;
三
検査箇所
the parts inspected;
四
検査の結果
the results of the inspection;
五
検査を実施した者の氏名
the name of the person who has carried out the inspection; and
六
検査の結果に基づいて補修等の措置を講じたときは、その内容
when measures such as repairs have been taken based on the result of the inspection, the details of the repairs.
When having found any abnormality in carrying out the self-inspection set forth in paragraph (1) or paragraph (2), the employer must make repairs or take other necessary measures.