Search

Search provisions, jump to a law or an article

1 article

Article 151-17Head Guard

第百五十一条の十七(ヘツドガード)

As regards a forklift, the employer must not use a forklift without a head guard that conforms to the following requirements; provided, however, that this does not apply if doing so is not likely to endanger the operator of the forklift due to falling of cargo:

事業者は、フオークリフトについては、次に定めるところに適合するヘツドガードを備えたものでなければ使用してはならない。ただし、荷の落下によりフオークリフトの運転者に危険を及ぼすおそれのないときは、この限りでない。

having the strength withstanding against the uniformly distributed static load equivalent to two times of the maximum load of the forklift (4 tons when the value exceeds 4 tons);

強度は、フオークリフトの最大荷重の二倍の値(その値が四トンを超えるものにあつては、四トン)の等分布静荷重に耐えるものであること。

having the opening of the upper frame with the width or the length of less than 16 cm;

上部わくの各開口の幅又は長さは、十六センチメートル未満であること。

having the height from the upper surface of a driver's seat to the lower surface of the upper frame of a head guard of 95 cm or more for the type of forklift operated by a driver sitting on its driver's seat; and

運転者が座つて操作する方式のフオークリフトにあつては、運転者の座席の上面からヘツドガードの上部わくの下面までの高さは、九十五センチメートル以上であること。

having the height from the floor surface of the driver's seat to the lower surface of the upper frame of the head guard of 1.8 m or more for the forklift operated by a driver standing.

運転者が立つて操作する方式のフオークリフトにあつては、運転者席の床面からヘツドガードの上部わくの下面までの高さは、一・八メートル以上であること。

Read this with the articles around it

© 2026 japanlaw.orgA copy for reading and reference — not an official source, and not legal advice. Only the Japanese text published by the government has legal effect.Run by Genjido LLC (源氏道合同会社) · contact@genjido.comContactSourcesTermsPrivacy